| Equipment |
|
|
| Basic conf guration: |
|
Basic
|
| -AIS Base Station Transponder (VDL 6000/FAS) |
| -LAN Converter |
| -Power Supply unit and AC flter |
| -19 inch rack |
| |
|
|
| Embedded hardware controller with basic |
|
Option
|
| software package |
|
|
| |
|
|
| Advanced software package |
|
Option |
| |
|
|
| Additional AIS Base Station Transponder (VDL 6000/FAS) in cold stand-by confguration for redundancy |
|
Option |
| |
|
|
| Additional AIS Base Station Transponder (VDL 6000/FAS) in hot stand-by confguration for redundancy |
|
Option |
| |
|
|
| IP Relay for remote switch on/off |
|
Option |
| |
|
|
| GNSS reference receiver to generate differential correction internally |
|
Option |
| |
|
|
| GNSS reference receiver antenna |
|
Option |
| |
|
|
Installation material:
- GPS antenna
- VHF antenna |
|
Option |
| |
|
|
| External Interfaces (basic conf guration) |
| Main Power |
|
110/240 V AC 50/60 Hz
|
| |
|
|
Service interface (AIS data and for remote control, conf guration and software
update) |
|
TCP/IP, RJ45 Ethernet
|
| |
|
|
| Local access interface (for local control, conf guration and software update) |
|
TCP/IP, RJ45 Ethernet or serial interface depending on confguration
|
| |
|
|
| VHF antenna(s) |
|
N-type female
|
| |
|
|
| GPS antenna |
|
TNC female |
| |
|
|
| Transmitter |
|
|
| Tuning range |
|
156.025 - 162.025 MHz
|
Channel spacing
|
|
12.5 and 25 kHz
|
Frequency stability
|
|
+/- 0.0002% = +/- 2 ppm
|
Tx to Rx turnaround time
|
|
< 1 ms
|
Channel selection time
|
|
< 26 ms
|
Antenna port impedance
|
|
50 ohm
|
Baud rate
|
|
9600 bps
|
Modulation scheme
|
|
25 kHz GMSK, 12.5 kHz GFSK
|
| Carrier power (adjustable) |
|
33 & 41 dBm (2 & 12.5 W) 50 Ohm load |
| |
|
|
| Receiver |
|
|
| Tuning range |
|
156.025 - 162.025 MHz
|
| Channel spacing |
|
12.5 and 25 kHz
|
| Modulation scheme |
|
25 kHz GMSK, 12.5 kHz GFSK
|
| Sensitivity, 20% MER |
|
<-107 dBm AIS 25 kHz, <-98 dBm AIS 12.5 kHz |
| |
|
|
| GNSS Receiver |
|
|
GNSS receiver
|
|
12 parallel channels
|
| DGNSS support |
|
Yes |
| |
|
|
Certif cation
|
|
|
CE-mark
|
|
Yes |
| The VDL 6000/FASS is based on the BSH certif ed Class A system |
|
Yes |
| |
|
|
Applicable Standards
|
|
|
IALA A-124
ITU-R 1371-1 with clarif cations
IEC 61993-2
IEC 61162-1 |
|
|
| |
|
|
| |
|
|
